Yale HSA3000 Dokumentacja Pobierz pdf (Strona 6)

Mounting alarm devices

Before mounting the keypad and siren ensure that the siren tamper is

disabled.

Mounting the siren

Ensure the tamper switch is fully depressed when

the siren is mounted. If there is a gap, pack with a

suitable spacing material.

Round

Siren

Base

Wall

Spring Guide

Spring compressed

firmly against wall

1 Using the large screws and wall plugs provided,

mount on the desired wall through the 4 mounting

holes. If there is a gap between the wall and the

tamper switch mechanism pack with a suitable

spacing material.

2 Fix the siren cover with the securing screw.

Mounting other devices

Find a location where the device is to be mounted,

see section “Location Planning” for suggestions.

Mounting the Keypad:

1 Knock out the ﬁxing holes. Drill holes into the wall

using the ﬁxing holes as a template.

2 Fit wall plugs into the wall and ﬁx back cover with

the screws provided. Fix front of the keypad onto

the back plate.

Battery Saver tab

Wall Fixing

knockouts x2

Mounting the PIR

1 Open the PIR by via the bottom screw. Knock out

the relevant holes at the base. The center two

knockout holes are for at wall mounting while the

4 side holes are for corner mounting.

Wall fixing

knockouts x2

Corner fixing

knockouts x4

Battery tab

2 Drill holes into the wall using the knockout holes on

the base as a template. Secure the base with the

screws provided.

3 Fit the PIR back together and tighten bottom

screw.

Before proceeding to mount the devices

physically, it is useful to check that it is not out of

radio range by doing a simple range test. Please

ensure the system tamper is disabled.

• Keypad: Hold the keypad in the desired

location and press the arm button.

(The siren will beep as conﬁrmation.)

• Help button: Hold the device in the

desired location and press the emergency

button for 2 seconds.

(The siren should respond with a single beep.)

• All other devices: Hold the device in the

desired location and press the learn/test

button.

(The siren should respond with a single beep.)

When you are satisﬁed that the devices work

in your chosen locations, proceed with the

installation as described in the next page.

If the siren does not respond, the location may be

out of range, try alternative locations until reliable

radio contact is obtained.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Komentarze do niniejszej Instrukcji

Brak uwag

Yale HSA3000 Dokumentacja Strona 6

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Yale HSA3000